Feature:

The average current control, two phase sinusoidal current drive output

Voltage supply: 24~80VDC

Photoelectric isolation signal input/output

With overvoltage, undervoltage, over current, and short circuit protection function

16 segment and half automatic flow function

Eight file output phase current Settings

With offline command input terminals

Motor torque is related to its speed, and has nothing to do with motor turn every steps

High starting speed

High torque

This drive only supports common anode connection, active low. Customers choose carefully!

Application:

Typical applications for stepper motor drive is All kinds of automation equipment and motion control of the organization, such as electronic processing and detection, semiconductor packaging, laser cutting and welding, laser typesetting, packing machines, engraving machine, marking machine, cutting machine, apparel plotter, waiting in the nc machine tools, etc. For the vibration of the motor itself, the output torque of noise and its accuracy and high speed have been improved obviously.

Specification:

Control signal definition

PUL+: Pulse signal input positive terminal

PUL-:Pulse signal input negative end

DIR+:Stepping direction signal input positive terminal

DIR-:Stepping direction signal input negative end

ENA+:Offline enable reset signal input positive terminal

ENA-:Offline enable reset signal input negative end

Offline enable signal is reset when a valid drive failure, prohibit any valid pulse, the output power of the drive element is turned off, the motor no holding torque.

Control signal connection

Control signal PC can be active high and to be active low. When the high effective, all the negative terminal of the control signal as the signal ground connected together, when active low, all the positive terminal of the control signal, as the signal common connected together.

Note: VCC value of 5V, R shorted;

When VCC is 12V, R is 1Kohm greater than 1/8W resistors;

when VCC is 24V, R is 2Kohm greater than 1/8W resistor;

R must be connected to the controller signal end.